Enzo Meris not controlable.

Question

Hi there,

I got midi designer loaded with the enzo Meris template ( v2.0) and an I rig midi 2 connected to the Meris via a Lehle midi cable ( SGoS Din-TRS ). The pedal doesn't respond to any change made on the app, although I notice the blue light of the i rig midi flashing. I'm new to this and I would like to learn how to configure and save presets of my Enzo via midi designer. Any help very welcome! Thanking you all in advance !

Answer 1

The layout is set to MIDI channel 7

Hi olorin the Meris layout is setup for channel 7 so you would need to either change the channel on the layout to the one the Enzo is set to by opening up the page control tab, and under control actions selection pick Renumber Controls, select your channel and select change channel only.  Alternatively you can change the pedal to channel 7.  Best of luck to you on your MIDI adventures.  - Mitch

Comments

Yes, you can contact meris to be 100% sure but I'm pretty confident their pedals do require either a meris MIDI I/O or another MIDI box. link - https://www.meris.us/product/midi-i-o/
 Also empress makes one - https://empresseffects.com/products/midibox2
(chase bliss and empress make cheaper ones, the advantage of the meris i/o being it sends MIDI out from the pedal on all four trs lines, I think the empress box send MIDI out on 1 line and the cb box will not send MIDI out via TRS only in)

---

Just wanted to check back in with you to see if you have had any progress with this?  I remember speaking with Meris about their pedals having to have a MIDI i/o or midibox to work with MIDI some time ago.

---

Hi, well I did try some extra things here and there, but now I'm even more lost. I bought an Empres Midibox2. I knew that I needed to do some mods on the pedal in order for it to work, so I de-soldered pin E4 and soldered pin E12 on the back of the board and checked electric connections ( see here : https://www.vguitarforums.com/smf/index.php?topic=24353.0 ) . Then I connected my i rig to the Ipad and start sending MIDI. I checked for channels ( there where OK, Enzo midi set on 7 and design layout on 7 too). Still nothing. I thought I needed a TRS cable instead of a normal patch jack. So I went to buy one. I did my last test a few minutes ago and still not an ounce of succes.  I'm now completely lost on this. Really don't know what to do. It seems that all the MIdi is being sent properly as I see the witness leds blinking. But the Enzo dos not react to any of it. It stays on the same setting whatever I do on the app. Thanking you in advance for any help you can provide me with.

---

I did it !!!!!! I forgot to set the enzo exp input to Midi !!!!     This changed everything!     Thanks a lot for your help !! Now let's the fun begin !! Cheers !

---

Great, I'm glad you got it working.  It is easy to miss the simple steps with all that complexity going on.

Answer 2

The layout is set to MIDI channel 7

Hi olorin the Meris layout is setup for channel 7 so you would need to either change the channel on the layout to the one the Enzo is set to by opening up the page control tab, and under control actions selection pick Renumber Controls, select your channel and select change channel only.  Alternatively you can change the pedal to channel 7.  Best of luck to you on your MIDI adventures.  - Mitch