Preset bugs..not recalling parameters

Question

I am using Midi Designer to control a midi controlled analogue resonant filter (Anatron) which we are building for commercial release. The functionality of Midi designer is superb and has greatly improved our endeavour  but I have run into a bug. Since setting up a super control for more preset storage than the standard 20 available it goes into lockup where bank 2 stops recalling parameters. This is also true for the 20 menu presets. If I reboot with no connections and run through the menu presets everything works, after loading one preset from the supercontrol bank 2 locks out until I reboot. The saved patches were working perfectly after I built them. I could switch between them no problem. Also sometimes the recall preset button stays lit until I press it again which as it is momentary seems strange.

The preset store recall setup was built exactly as the one in the video tutorial with momentary store recall buttons. It is storing about 40 parameters over 4 banks setup as 2 big pages.

Is this a known bug? any help would be appreciated

Comments

Hey there, no, it's not a known bug, and we do love fixing bugs. Any interest in creating a self-contained simplest-possible example of the bug (if that's possible)? That would help a lot, both to see the bug and to use as a test-bed for fixing the bug. You could even use the upload functionality from the App to add it to your question here!

http://mididesigner.com/qa/108/how-can-i-upload-a-normal-file-in-an-answer-on-this-q%26a-site?show=4962#a4962

Thank you!
Dan (Author)

Answer 1

MDP 2.2 has been submitted for review: it fixes this issue with XY Pads on Page-Make-Similar and Page-Load. Thanks!

Comments

I have issue with presets and working on separating the page with problem from the rest of the template. I have 20x4 controls split to two preset supers. I did started with 12 values as video shows even I would only need 4 presets and have them controlled via another button group. Example of less than 12 presets:  a) zero controls, b) set LFO matrix, c) set ENV3 matrix... (this is for Novation Circuit template). I cannot do this via global preset b/c I don’t NEED TO CHANGE another 3-4 pages of controls. So to be local with presets is GREAT I just it worked when you have many many controls.  

Yes I red somewhere that presets don’t work properly if there is channel changer as super and I do have those 80 controls under yet another super that changes the MIDI channel.  

Very frustrated, All I need to ZERO 4x10 controls to SOME initial state. I noticed also that I have a preset on another page that AFFECT this page and the Supers are not shared the only thing is shared between those pages is Channel Changer could that be the issue ?

---

Thanks, is this your question here?

Answer 2

MDP 2.2 has been submitted for review: it fixes this issue with XY Pads on Page-Make-Similar and Page-Load. Thanks!