LSB and MSB midi messages. How to create?

Question

I have this knob that has an msb of  CC17 and an lsb of CC 20 to control the cutoff. Cutoff values range from 0 to 255. How do I set this up so that I have one control that goes from 0 to 255?

Comments

So how do I configure this in MD? Do I take the LSB or the MSB as the CC in a control? I would think the LSB.

---

Thanks, just put this up there now: http://mididesigner.com/qa/277/coarse-fine-ccs-14-bit-control-changes?show=2831#a2831

---

Awesome. Another thing learnt about MD.

---

So what about the original questions with 17 and 20... was that an error?

---

You can forget about the 17 and 20. I don't remember where I saw it,but my guess is that I didn't pay attention.

Answer 1

According to the OP, the 17-20 was erroneous (it was no doubt 17 and 49).

That's a 14-bit CC. We support it in MD.

http://mididesigner.com/qa/277/coarse-fine-ccs-14-bit-control-changes?show=2831#a2831

 

Answer 2

According to the OP, the 17-20 was erroneous (it was no doubt 17 and 49).

That's a 14-bit CC. We support it in MD.

http://mididesigner.com/qa/277/coarse-fine-ccs-14-bit-control-changes?show=2831#a2831