Buttons in a group sending multiple commands.

Question

I am currently testing the free version of this app before I buy.  The purpose of the purchase would be to control my entire guitar rig. I have a kemper profiler, multiple analog pedals connected to a midi pedal switcher and a line 6 m9. My attemp is to use my FCB1010 to trigger preset buttons on the MIDI designer and the midi designer to control all my gear. This way I don't have to program the FCB1010 which is a pain.  So far, I've been able to control the Kemper and the analog pedals succesfully. However, I am having issues with the M9.

The M9 has 4 folders with 6 scene available in each folder. These are accessed through program changes 0 - 23 as you can see in the picture below.

I've set up buttons (either in Momentary or Toggle modes) to send the program changes, but Folders 1 and 2 buttons are in a group using a Knob. By having them in a group I'll be able to know which preset is currently active. The problem I am having is that when a preset is selected through one of the grouped buttons the M9 seem to be receiving multiple message and going through many presets before arriving to the desired one. This causes the M9 to make all kinds of noises if I am playing the guitar.  However, when I use the Buttons that are not in a group, the desired preset is selected immediatedly.

I've uploaded a few short videos that were recorded with my phone to dropbox. In one of the videos you'll be able to see the lights of the M9 going through many preset when selecting a button in a group (Toggle in group.mp4).  And how a preset is selected immediatedly when selecting a button not in a group (Toggle no group.mp4).   

I hope there's a function available that I haven't figured yet to remedy the issue. Using this program would really simplify my programming and since the FCB1010 doesn't have a digital display, having a screen to see what's going on would be fantastic.

Thank you in advance for your help,

Luis Robles

 

 

UPDATE 4/30/2014

 

Ok I figured out what was happening or at least this is how I got it to work.  I needed to set the buttons in the group to send only and the knob(supercontrol) subtype to OFF.  I am almos done with the design. Here's a picture and a link to the layout.

Here's the Layout.

Comments

Hey Luis, so this is resolved, right?