Mididesigner Smith FCB101

Question

i try tu use midi with fcb 1010 pedal board but in fact when  i Make a supercontrol i think the fcb 1010 send 2 information when  i press the pedal because i want send only 1 command to the control

could You help me ?

Comments

Perhaps your FCB1010 is using toggles when you want it to use momentaries? Not sure I understand the question yet, but I'd love to. Thanks!

Answer 1

I had the same issue! I ended up programming the FCB to just send a midi note message for each button as they're momentary. I believe unless you get the 'uno' upgrade EPROM for th FCB, the messages it sends are latching for CC's etc. I'm not 100% sure on that though. As for the sending multiple messages, by default I think the FCB sends CC's out for the two expression pedals, so you may need to switch those off from the FCB, which is easily done. That's what I did anyway and it's been working fine since!

Comments

In fact i have juste click on "14 bit cc" in midi and he work fine with jamup now

Answer 2

I had the same issue! I ended up programming the FCB to just send a midi note message for each button as they're momentary. I believe unless you get the 'uno' upgrade EPROM for th FCB, the messages it sends are latching for CC's etc. I'm not 100% sure on that though. As for the sending multiple messages, by default I think the FCB sends CC's out for the two expression pedals, so you may need to switch those off from the FCB, which is easily done. That's what I did anyway and it's been working fine since!