Preset Doesn't Send to Alpha Juno 2

Question

Was "I am having the same problem with 1.4.5 Build 1450 - doesn't save though it seems to."

Comments

I just opened the log and looked at what was being sent.  The Chorus Rate parameter changes get sent as I move the knob. However, after I save the change and call up the Preset, it just sends one system message - resetting the Chorus rate to the same spurious value it had before the save, as though I hadn't made any changes.

FWIW -
Andy

---

Appreciate your attentiveness. Looking forward to a solution. Really glad to have purchased such a well-supported product!

---

So we're not overwhelming the synth with these presets. So are you able to send a sysex in a preset--assuming the knob is set to the wrong value--to the Roland midi target?

---

If you mean does the synth get all the sysex messages that appear in the Log, the answer is apparently yes. The T4 value that I altered and saved in the Preset, was sent back to the synth as it should have. So was the spurious Chorus rate, which kept coming back at a value of 65 no matter how many times I tried to change it and save it.

Hope this answers you succinctly -

Andy

---

"However, after I save the change and call up the Preset, it just sends one system message - resetting the Chorus rate to the same spurious value it had before the save, as though I hadn't made any changes."  If I'm reading this correctly, I'll have to check out how presets work with sysex, I think.